Electric heat testing
Element, thermal fuse, thermostats and the power feeding the dryer checked.

Laundry
A dryer that tumbles but stays cold usually has one failed heat part and sometimes a blocked vent behind it. We check both.
Call or text today615-431-3789Dryer Not Heating Repair
On an electric dryer, no heat usually means a burned heating element, a blown thermal fuse or a failed thermostat, and sometimes a tripped breaker on one leg of the circuit. On a gas dryer, the igniter, the gas valve coils and the flame sensor have to work together. A blocked vent is often the reason a thermal fuse blew in the first place, so replacing the fuse alone can fail again.
We repair no-heat dryers across Middle Tennessee, from older gas dryers in Nashville basements to electric dryers in new townhomes. We test the circuit, the heat parts and the vent, replace what failed and show you why it happened.
What you get
Element, thermal fuse, thermostats and the power feeding the dryer checked.
Igniter, valve coils, flame sensor and gas supply tested in order.
Lint blocks that cause overheating are found and cleared.
We run a full heated cycle before we leave.
The process
We check the breaker, the outlet and the gas supply.
We test the element or igniter chain and the safety parts.
We replace the failed parts and confirm the dryer heats.
FAQ
It is a simple part, but it blew for a reason, usually a blocked vent. If the cause is not fixed, the new fuse can blow too.
Half a heating element, a weak gas flame or restricted airflow can all give weak heat. We test each.
Yes. Electric dryers use two circuits, and one tripped leg can leave the drum turning with no heat. We check the power first.
Service areas
From Clarksville to Shelbyville and Dickson to Cookeville, pick your city to see the appliance repair and installation work we handle in your part of Middle Tennessee.
Not on the list? Call 615-431-3789. We take projects across Middle Tennessee.
Call, text or send the form. Tell us about the appliance and we will take it from there.