Skip to main content
615 Appliances, appliance repair and installation in Nashville TN 615-431-3789

Laundry

Top-load washer repair for agitator and impeller washers that will not agitate, drain, spin or fill, or that vibrate hard

Top-loaders fail in a handful of predictable ways: couplers, lid switches, drain pumps and worn drive parts. We diagnose and repair them.

Call or text today615-431-3789

Request appliance service

Tell us what is going on. We will contact you to confirm the details and set up a time to look at the job.

Or call 615-431-3789

By sending this you agree that we may contact you about your project. See our Privacy Policy.

Prefer to type? Text your request to 615-431-3789

Top-Load Washer Repair

Top-load washers use either a central agitator or a low-profile impeller, and both depend on a motor coupler, a transmission or drive, a lid switch and a drain pump. A washer that fills but will not agitate, that makes a grinding or clicking noise, or that stops spinning mid-cycle is often missing a drive part rather than dead.

We repair top-loaders across Middle Tennessee, including older machines in Nashville homes with long-lived laundry rooms and newer high-efficiency models. We check the lid switch, coupler, belt or clutch, pump and suspension, then explain the options.

What you get

Done right, from the first call

01

Agitator and impeller service

Worn dogs, couplers and impellers diagnosed and replaced.

02

Lid switch and control checks

Switch faults and board problems that stop the cycle.

03

Drain pump and hose service

Pumps and hoses cleared or replaced when water will not leave.

04

Suspension and balance repair

Springs, rods and leveling checked when the tub bangs.

The process

How your service comes together

  1. 1

    Describe the cycle

    Tell us where the washer stops and what you hear.

  2. 2

    Test the drive and pump

    We check the lid switch, drive parts, pump and suspension.

  3. 3

    Repair and test

    We replace the failed part and run a load.

FAQ

Common questions about top-load washer repair

Why does my washer fill but not agitate?

A worn coupler or drive part is a common cause. We test the motor and drive to find which part has failed.

Why does the washer bang during spin?

An uneven load, an unlevel machine or worn suspension are typical causes. We check all three.

Can I repair a washer that is more than ten years old?

Often yes if parts are available and the tub is sound. We tell you what the repair involves before we start.

Let us help with your top-load washer repair

Call, text or send the form. Tell us about the appliance and we will take it from there.

615-431-3789Text