Safe drain and cleanout
Standing water removed without flooding the floor.

Laundry
A drum full of standing water is the most common washer call. We find out whether it is a clog, a pump or a control problem.
Call or text today615-431-3789Washer Not Draining or Spinning Repair
When a washer will not drain, the usual suspects are a blocked drain hose, a clogged pump filter, a failed pump or a lid or door switch that stops the cycle. When it will not spin, the cause may be a worn belt, a failed motor control, a bad lid switch or a load that is out of balance. The symptoms overlap, so a short test sequence separates them.
We handle drain and spin faults across Middle Tennessee, from basement laundry rooms in older Nashville homes to second-floor hookups in townhomes. We drain the tub safely, clear the blockage, test the pump and drive and run a full cycle.
What you get
Standing water removed without flooding the floor.
Filters, hoses and the pump housing cleaned of coins and lint.
Spin faults traced to the drive or the safety switch.
Home drain connections checked when the problem may be on the house side.
The process
We safely remove the water and check for the obvious clog.
We test the pump, belt, motor and safety switches.
We replace the failed part and run a drain and spin cycle.
FAQ
You can, but unplug the washer first and use towels carefully. A clog will refill the tub, so the cause should be cleared.
If a sink or tub nearby drains slowly too, the problem may be the house drain. We check the standpipe as part of the call.
A lid switch, belt, motor control or an unbalanced load can all stop the spin. We test each.
Related services
Service areas
From Clarksville to Shelbyville and Dickson to Cookeville, pick your city to see the appliance repair and installation work we handle in your part of Middle Tennessee.
Not on the list? Call 615-431-3789. We take projects across Middle Tennessee.
Call, text or send the form. Tell us about the appliance and we will take it from there.